ImposeIQ Suite · Door hangers
ImposeIQ Door Hanger Creator
Build a door hanger as the die-cut card that gets printed, and see it hanging on a door knob or a lever handle in 3D.
Capabilities
The right hole, the right slit, checked.
Choose from nine dies and swap any hole for another. The checks warn when a hole is too small for a door knob, leaves too little card beside it, or a perforation runs too close — before the die is ordered.
- Round hole with slit, round hole, open-side hook, keyhole, arch top, house top, tear-off coupon, oval hole and rounded slot
- 3½ × 8½ and twelve more standard sizes, metric included, or any size typed in
- Hole sizes from 1″ to 2″ matched to the hanger width, or any width typed in
- Slits up and out, straight out or straight up, opening left or right
- Square, rounded, arched or peaked tops
- Tear-off perforation for a coupon or reply card
- Front and back views with the cut and perforation lines, and a 3D view on a knob or lever
- Artwork slots, variable data, Spot UV and foil plates, and templates
Typical workflow
How it works.
- Pick a dieFrom the nine on the start screen.
- Set the hole and sizeHole cutout, slit, top and perforation.
- Place the artworkFront and back, with any finishes.
- Write the filesThe print PDF with its die line, ready for the Imposer.
See it on the door first.
Included with the ImposeIQ Suite for Windows.